Then check the Com port settings in our program under Settings/Communication. Set it to an unused port number 1 through 5. In Windows XP, you can do this by going to Control Panel, System, Hardware, Device Manager, Ports, Communications Port, Port Settings, Advanced, then click on the Com port pull-down and it will show you which Com ports are in use on your machine.
#Pdf toolbox v6 install#
You will have to install the drivers that come with the device and then go into control panel on your PC and manually set the Com port to Com 1 through Com 6, as these are the only ports our program will operate on. If you don't have one yet, you can order one from us (P/N 551-1691) or pick one up from almost any electronics parts store (Fry's, Radio Shack, etc). The Sitemaster and the Handheld Software Tools program (HHST) will work with almost any commercially available USB to Serial adapter. Anritsu (551-1691) If an earlier version of Handheld Software Tools is being used, only the Anritsu supplied adapter will work. The following USB to Serial adapters have been evaluated by Anritsu and have been confirmed to work properly. Most of the USB to Serial adapters available today in the market will work, provided the computer uses an operating system that supports USB interfaces and that Handheld Software Tools (Version 6.49 or above) is used. It is important to note that the adapter can not be used to communicate with the Handheld Code Loader software and can only be used to communicate with the Anritsu Handheld Software Tools (Version 6.49 or above) to download and upload traces. To address this issue, a USB to Serial adapter can be used. Most of the new lap top computers available in today's market do not feature an RS-232 serial port but feature a Universal Serial Bus (USB) port instead. All the Site Master, Cell Master and Spectrum Master Products (excluding MS2721A) include an RS-232 serial port.
0 kommentar(er)
